Inserting/Removing The Battery/Card (Optional) - Panasonic LUMIX DMC-FS42 Operating Instructions Manual

Inserting/Removing the Battery/Card
• Check that the camera is turned off.
• We recommend using a Panasonic card.
1
Slide the release lever in the direction of
the arrow and open the card/battery door.
• Always use genuine Panasonic batteries.
• If you use other batteries, we cannot
guarantee the quality of this product.
2
Battery: Insert it fully being careful about
the direction for insert. Pull the lever A
in the direction of the arrow to remove
the battery. Card: Push it fully until it
clicks being careful about the direction
for insert. To remove the card, push the
card until it clicks, then pull the card out
upright.
B Do not touch the connection terminals of the
card.
• The card may be damaged if it is not fully
inserted.
3
1: Close the card/battery door.
2: Slide the release lever in the direction
of the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
• Remove the battery after use. Store the removed
battery in the battery case (supplied).
• Do not remove the battery until the LCD monitor turns off as the settings on the camera
may not be stored properly.
• The supplied battery is designed only for the camera. Do not use it with any other
equipment.
• Before removing the card or battery, turn the camera off. (Otherwise, this unit may no
longer operate normally and the card itself may be damaged or the recorded pictures
may be lost.)
Preparation
- 14 -
(Optional)