Before Mounting - Sony XS-GT5738F Instructions Manual

Mounting
I
Montag~
BaaHOBIIeHHJI/
=Jz;.:
Before mounting
A depth of at least 58 mm (2
3
/s in) is required for
flush mounting. Measure the depth of the area where
you are to mount the speaker, and ensure that the
speaker is not obstructing any other components of
the car. Keep the followings in mind when choosing a
mounting location:
• Make sure that nothing is obstructing around the
mounting location of the door (front or rear) or the
rear tray where you are to mount the speaker.
• A hole for mounting may already be cut out of the
inner panel of the door (front or rear) or the rear
tray. In this case, you need to modify the board only.
• If you are to mount this speaker system in the door
(front or rear), make sure that the speaker terminals,
frame or magnet do not interfere with any inner
parts, such as the window mechanism in the door
(when you open or close the window), etc.
Also make sure that the speaker grille does not
touch any inner fittings, such as the window cranks,
door handles, arm rests, door pockets, lamps or seats
etc.
• If you are to mount this speaker system in the rear
tray, make sure that the speaker terminals, frame or
magnet do not touch any inner parts of the car, such
as the torsion bar springs (when you open or close
the trunk (boot) lid), etc.
Also make sure that the speaker grille does not
touch any inner fittings, such as seat belts, head
rests, center brake lights, inner covers of the rear
wipers, curtains or air purifiers, etc.