TDS e28 User Manual page 25

Exit Without Saving
Set Password
Pressing <Enter> on this
item for confirmation:
Quit without saving (Y/N)?
Y
Pressing <Enter> on this
item for confirmation:
ENTER PASSWORD:
This allows you to exit Setup without storing
any changes
selections remain in effect. This shall exit the
Setup utility and restart your computer.
When a password has been enabled, you will
be prompted to enter your password every
time you try to enter setup. This prevents
unauthorized persons from changing any part
of your system configuration.
Type the password, up to eight characters in
length, and press <Enter>. The password
typed now will clear any previous password
from the CMOS memory. You will be asked to
confirm the password. Type the password
again and press <Enter>. You may also press
<Esc> to abort the selection and not enter a
password.
To disable a password, just press <Enter>
when you are prompted to enter the
password. A message will confirm that the
password will be disabled. Once the password
is disabled, the system will boot and you can
enter Setup freely.
25
E28 User Manual
in CMOS. The previous