Table of Contents
Advertisement
OBJ_BUCH-1304-001.book Page 19 Wednesday, August 18, 2010 10:12 AM
– Press the tool arm in the direction of the
fence 15 and saw through the workpiece ap-
plying uniform feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length
(see figure O)
The length stop 14 can be used for easily sawing
workpieces to the same length.
– Fold the left or right length stop 14 upward.
– Adjust the saw table extension 13 to the de-
sired length (see "Extending the Saw Table",
page 16).
Adjusting the Depth Stop (Sawing Grooves)
(see figure P)
The depth stop must be adjusted when a butt
gap is to be sawed.
– Push the locking lever 4 and lower the tool
arm to the desired position.
– Swivel the depth stop 46 outward.
– Turn adjusting screw 22, until the screw end
touches depth stop 46.
– Guide the tool arm slowly upward.
Sawing Profile Strips
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw
table
In addition, the cut can be perfomed with or
without slide movement depending on the
width of the profile strip/moulding.
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Bosch Power Tools
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
Transport (see figure Q)
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Lock saw-table extensions 13, ring spanner
16 and material clamp 17 with the corre-
sponding fastening screws 32, 48 and 29.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the machine by the transport handle 2
or hold it by the recessed grips 47 on the
sides of the saw table.
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
1 609 929 X24 | (18.8.10)
English | 19
Hide quick links:
Advertisement
Table of Contents
