Table of Contents
Advertisement
Mounting the DLT-U1100
5. Mounting the DLT-U1100
5.1. Important notes – read before installation
5.1.1.
Only electronic and mechanical skilled persons
WARNING: Electric shock due to contact with live parts / property damage
Only electronic and mechanical skilled persons are permitted to install the DLT-U1100 UPS.
Specialized knowledge of batteries and the applicable safety regulations is also required.
If the DLT-U1100 is incorrectly installed and configured, the DLoG GmbH warranty for this device will be
canceled.
DLoG GmbH assumes no liability for damages caused directly or indirectly by the incorrect installation or
usage of the DLT-U1100.
5.1.2.
Admissible locations
WARNING: Explosion hazard
Do not use the DLT-U1100 at locations where flammable gases or vapors are present.
Do not use the DLT-U1100 near gas stations, fuel depots, chemical facilities or locations where blasting
work is being performed.
Do not throw the DLT-U1100 into fire; the batteries may explode.
5.1.3.
Modification, repairs and handling of batteries
WARNING: Electrical shock possible from touching live parts / property damage
Do not commission the DLT-U1100 if there are visible signs of damage to the device.
The DLT-U1100 contains Lithium Ion batteries. Replacement of the rechargeable batteries by the
customer is expressly prohibited.
Do not open or modify the DLT-U1100.
Do not perform any repairs. Repairs on the DLT-U1100 may be made only by Service Centers
authorized by Advantech-DLoG.
Do not submerge the DLT-U1100 and cables in water or other liquids because of the danger of electrical
shock.
Use only original power cables by Advantech-DLoG; they meet special requirements for low-temperature
flexibility, UV resistance, oil resistance, etc.
Condensation can occur if the DLT-U1100 is moved from a cold environment into a work room.
Therefore, allow for an acclimatization time of approx. 2 hours.
Page 16 of 26
DLT-U1100 Manual V1.00
Advantech-DLoG
Advertisement
Table of Contents
