Craftsman 580.752890 Operator's Manual page 14

How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension. There is also a
detachable hose wrap at the back of the accessory tray to
hold your high pressure hose.
1. Place nozzle extension and selector nozzle through hole
on accessory tray on left side of unit.
2. Place spray gun through hole on accessory tray on right
side of unit.
NOTICE You may also use the spray gun holder on the
accessory tray to store your spray gun, nozzle extension and
selector nozzle as shown in Features and Controls section.
3. Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
4. Hook provided on back of accessory tray for safely
storing safety goggles.
How to Use Selector Nozzle
The selector nozzle allows you to switch between five
different spray pattern nozzles. Spray patterns can be
changed while pressure washer is running once spray gun
trigger safety lock is engaged. The spray patterns vary as
shown below.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER change spray patterns without the trigger locked on the
spray gun.
• DO NOT twist selector nozzle while spraying.
Follow these instructions to change nozzle patterns:
1. Select desired spray pattern:
• MAX - For stubborn or hard to reach surface such
as second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.).
2700 PSI
2.1 GPM
2650 PSI
2350 PSI
2.2 GPM
2.3 GPM
• GENERAL - For most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc..
• DELICATE - For gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment, etc..
• FLUSH - For quick high flow clean up and long
reach cleaning of second story siding and windows.
• SOAP - For general soap applications or to launch
soap to second story siding and windows.
2. Push button on selector nozzle, nozzle dial will pop up.
3. Turn dial until desired spray pattern lines up with button
on selector nozzle.
4. Push dial in until it locks into place.
Usage Tips
• For most effective cleaning, keep selector nozzle from
8 to 24 inches (20 to 61 cm) away from cleaning surface.
• If you get selector nozzle too close, especially using a
high pressure spray pattern nozzle, you may damage
surface being cleaned.
• DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
How to Use Surface Cleaner
The surface cleaner has dual high pressure water jets that
spin rapidly breaking up dirt and grime without streaking or
striping surfaces. The 12 in. (30.5 cm) wide surface cleaner
gently glides across surfaces, quickly and easily cleaning
large horizontal areas such as garage floors, driveways and
patios. The lightweight enclosure contains the spray,
eliminating messy overspray and backsplash.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
• DO NOT lift or tilt surface cleaner from horizontal surface while
connected to spray gun. Release spray gun trigger prior to
lifting or tilting.
• ALWAYS press red button and squeeze spray gun trigger to
release high pressure, every time you stop engine.
14