Table of Contents
Advertisement
Getting Started
This OneRemote DAB+/FM/WiFi tuner has been re-designed for operation in a Bang & Olufsen remote
control system, allowing full control with a Bang & Olufsen remote control terminal either directly or via
connection to Bang & Olufsen equipment.
Thus the tuner is BeoLink compatible.
If the Bang & Olufsen system comprises one or more link rooms in a BeoLink System, sound may be
distributed to these rooms, and in some cases – see below – the tuner might even be controlled from
there.
Operation details described below require correct connection of the tuner to the Bang & Olufsen system.
When initially powered up the DabWiFi2 tuner is programmed to be switched on by pressing
y
on the Bang & Olufsen remote. In most cases though reprogramming shall be carried out during
this initial installation. See below.
Hereafter the daily operation shall – in most cases - be limited to selecting a pre-set favorite program.
The OneRemote DabWiFi2 tuner is supplied with a DataLink cable enabling connection to most Bang &
Olufsen radios. But some system configurations require an adaptor as shown later in this manual and
explained in detail in the Installation Manual.
Direct Control or CableLink Control
The OneRemote DabWiFi2 tuner connects to Bang & Olufsen equipment with the 7-pin DIN-cable with or
without adaptor, and through option programming it may be controlled as follows:
1. Via the tuner's built in IR-receiver,"Direct Control"
Direct Control is used, when connection to an input with control data is not possible. The tuner is
controlled directly with a regular Bang & Olufsen remote.
2. Via the cable connected Bang & Olufsen equipment,"CableLink Control"
CableLink Control is used, when connection to an input with control data is possible with the 7-pin
DIN cable. All the control data passes through the connected Bang & Olufsen equipment.
If DabWiFi2 is not connected to the Bang & Olufsen equipment as a
programming has to be changed to the source corresponding to the used input. Check Option
Programming below.
The OneRemote DabWiFi2 tuner is supplied initially programmed for direct control.
www.oneremote.dk
B&O Remote control model
Beo4, Beo5, Beo6 or BeoOne
Beolink 1000
Source
b
y
b
y
/
source, the option
b
or
3
Advertisement
Table of Contents
