Safety Precautions - Hyundai Seasall D170s Installation & Operation Manual

SAFETY PRECAUTIONS

Read and understand this operator's manual
as well as other information supplied by
Hyundai SeasAll for safer use of these
products. Be sure to check your engine
regularly.
• Do not use the engine for a purpose other
than what is intended by Hyundai SeasAll. Do
not modify the performance of the supplied
engine without the express permission of
Hyundai SeasAll. This can be dangerous, can
shorten the life of your engine and can
invalidate your warranty.
• Original and genuine parts supplied from
Hyundai SeasAll must be used for
inspections and maintenance. Hyundai
SeasAll does not guarantee any damage
caused by the use of imitation parts.
• Engine inspection and maintenance should
be carried out by properly trained and factory
approved service engineers.
• The engine should be inspected if the
electronic engine control unit shuts down the
engine or puts it into the "limp home" mode.
INSTALLATION & OPERATION MANUAL
D170 and D150 Series Engines
HOT SURFACES AND FLUIDS
• There is always a risk of burns when working
with a hot engine. Be aware of hot parts like
the turbocharger system, the exhaust system,
hot coolant hoses, etc. Wait until the engine
is fully cool to do inspection and maintenance.
REFUELING
• Refuel only after the engine completely
stops.
• Use only the recommended fuel. The wrong
grade of fuel can cause operating problems,
can cause the engine to stop and can cause
engine damage.
• Pay special attention to safe practices when
refueling.
PAINT DAMAGE
• Damage of the engine or parts paint during
maintenance and inspection can cause
corrosion. Any damage must be repainted
after inspection and maintenance.
WELDING ON ENGINE
• Welding directly on the engine block can
cause damage to the engine control systems.
The ECU and related electronic devices must
be disconnected and removed if unavoidable
welding is needed.
-4-