Table of Contents
Advertisement
3.3.1 POWER IN
This connector is meant for the connection of MX-20P power supply box.
Note:
This connection for Alto power supply only!
3.3.2 SPEAKER OUT
These connectors are meant for connection of the speakers. For your safety, please be careful when
connecting.
3.3.3 MAIN OUT
Both MAIN output and TAPE output are RCA type connectors. Through the MAIN output you can connect your
MX-20P to an amplifier. Through the TAPE output you can connect your MX-20P to a tape recorder.
19
3.3.4 INPUT
- PHONO input: Both Channels feature PHONO inputs including RIIA preamplifier for the turntable. PIN (RCA)
connectors shall be used to connect the turntable.
- LINE input: Through these RCA connectors you can connect a CD player, an MD player or any other high level
device such as Tape Recorder, DAT, etc..
Important Notice: If you wish to connect LINE level devices into the LINE/PHONO input, make sure that the LINE/
PHONO switch is on LINE position otherwise the sensitive RIAA preamplifier built-in in the Phono input will be
overloaded and will generate distortion.
3.3.5 GND Screw
GND is the supplementary grounding selection for other connected instruments.
3.4 The Power Supply Box
16
17
18
20
23
FUSE:T2AL
AC INPUT 210-240V 50Hz
POWER CONSUMPTION 400W
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
21
24
DC OUTPUT
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
AVIS: RISQUE DE CHOC ELECTRIQUE
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
25
9
22
- DO NOT OPEN
- NE PAS OUVRIR
POWER
MODEL
SERIAL
ON
OFF
Advertisement
Table of Contents
