About Indicators; Error Handling - Sony VPL-GTZ1 Quick Reference Manual

Error Handling

About Indicators

The WARNING1 or WARNING2 indicator lights up or flashes if there is any trouble with your
projector.
Flashing/Lighting indicators
(Flashes in red)
Both indicators flash
Note
If the indicator starts flashing in a way of other than the above, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
20
GB
WARNING1
indicator
The number of
flashes
Three times
(Flashes in red)
Six times
Twice
Three times
(Flashes in red)
If there is any problem or an error message appears on the
screen, refer to "Error Handling" in the Operating
Instructions contained in the supplied CD-ROM.
WARNING2
indicator
Cause and Remedy
The temperature of the light source is
unusually high. Turn off the power and
wait for the light source to cool, then turn
on the power again.
If the symptom persists, the light source
may be at the end of its service life. In this
case, consult with qualified Sony
personnel.
The unit detects a drop impact.
If there is abnormality on the unit, consult
with qualified Sony personnel.
If there are no abnormalities on the unit,
disconnect the AC power cord and check
that the LED indicator turns off, then
connect the AC power cord and turn the
unit on.
The internal temperature is unusually high.
Check to ensure that if nothing is blocking
the ventilation holes or whether or not the
unit is being used at high altitudes.
The fan is broken. Consult with qualified
Sony personnel.