Cleaning; To Clean The Filter In The Inlet Valve; To Clean The Lint Filter; To Clean The Pump Casing (For Pump Model) - LG WF-T5001(~2)PC(H/P) Owner's Manual

C
leaning
When water supply into the tub is not clean or the filter is clogged with particles(Such
as sand), clean the filter in the inlet valve occasionally.(The figure of power cord and
water tap may vary according to the country)

To Clean the Filter in the Inlet Valve

Close the tap before turning off the
1
power.
Select both hot/cold and then press the
[START/PAUSE] button to remove
water from the machine completely.
After removing the water
3
supply hose pull out the filter.
Then use a brush to clean
the filter.
Caution
Before cleaning the filter, the impurities in the water supply hose should be removed.

To Clean the Lint Filter

1
Pull out the lint filter from
the tub in the direction
shown below.
Note
• If the lint filter is torn or damaged, purchase a new one from LG service center.

To Clean the Pump casing (for pump model)

1
Unfasten 4 screws of the
back cover.
Self-cleaning function(for pump model)
In the initial stage of every washing machine process, the drain pump works for 3~5 seconds to pump out
water with dirt from the washing tub. It helps to keep the wash tub clean and improve pumping ability.
Caution
• Check if water leaks after reassembling. (The Rubber ring is in the cap)
2
4
2
Turn the net inside out
to clean the filter and
rinse it with water.
2
Turn the cap as shown in
diagram and unfasten it.
Remove foreign objects such
as pin, button, coin, etc
(Bottom view)
Turn off the power before
pulling out the cord.
Replace the filter after cleaning it.
3
Replace- the filter to the
original location. Push the
lip of the filter until a pop
sound is heard.
3
Reassemble the cap to
the arrow direction and
fasten it.
(Bottom view)
23