Chevrolet 2012 Corvette Owner's Manual page 193

Finding a Station
BAND: Press to switch between
FM1, FM2, or AM.
/ (Tune): Turn to select radio
stations.
SEEK : Press to go to the
previous or to the next station and
stay there.
The radio only stops at stations with
a strong signal.
SCAN : Press and hold
or for two seconds until
FREQUENCY SCAN displays. The
radio goes to a station, plays for a
few seconds, then goes on to the
next station. Press or
stop scanning.
To scan preset stations:
Press and hold
four seconds until PRESET SCAN
displays. The radio goes to the next
preset station, plays for a few
seconds, then goes to the next
preset station. Press
or press one of the pushbuttons to
stop scanning presets.
The radio only scans stations with
a strong signal.
1 6 (Preset Pushbuttons):
Press to play stations that are
programmed to the radio preset
pushbuttons.
again to
Infotainment System
Storing Radio Stations
Drivers are encouraged to store
or for
radio station while the vehicle is
parked. See Defensive Driving on
page 9 3. Tune to stored radio
stations using the presets, favorites
button, and steering wheel controls,
or again
if the vehicle has this feature.
Up to 30 stations (six FM1, six FM2,
six AM, six M1, and six XM2), and
equalization settings for each
station can be programmed on the
six numbered pushbuttons.
To set presets:
1. Turn the radio on.
2. Press BAND to select FM1,
3. Tune in the desired station.
4. Press AUTO EQ to select the
5. Press and hold one of the
6. Repeat the steps for each
FM2, AM, XM1, or XM2.
equalization.
six numbered pushbuttons until
the radio beeps once.
pushbutton.
7-7