Table of Contents
Advertisement
ECG WIRE DRESSING (KV-30HS420/34HS420 ONLY)
2-022-978-01
Wire Clip (2 Places)
NOTE: Leads are
dressed inside
Rotation Coil.
ECG - P/N
1-900-808-30 - 30 WCRT
1-900-808-31 - 34W CRT
ECG WIRE DRESSING (KV-32HS420/36HS420 ONLY)
Caution Points:
1. Make sure braided ECG wire loop does not
twist, and stays flat on CRT surface.
2. Do not pull excessively on the tension spring.
3. If the spring appears warped or stretched,
replace entire parts. The braided ECG wire
CANNOT sag on the CRT, and must remain
under tension.
Earth Coating
Ground Wire (ECG)
32": 1-900-808-29
36": 1-900-808-28
KV-27HS420/29DRC420/30HS420/32HS420/34HS420/36HS420
NOTE2: There are
2 Leads (TOTAL 4
Wires) to connect
to CH-Board
Rotation
COIL
DY
SPRING (2 places)
Integral part of
the Ground wire
CRT BRKT
(Earth Coating Ground)
NOTE: Leads are
dressed inside
Rotation Coil.
Rotation
DY
COIL
CRT BRKT
KV-27HS420/29DRC420/30HS420/32HS420/34HS420/36HS420
NOTE2: There are
2 Leads (TOTAL 4
Wires) to connect
to CH-Board
Integral Spring
2-Places
17
Hide quick links:
Advertisement
Table of Contents
