Recalling Preset Codes - Pioneer VSX-C550 Operating Instructions Manual

Recalling Preset Codes

The following steps show you how to recall preset codes
for each Input/Control Mode Select button or the TV
CONTROL buttons. In the former case, once the preset
code is assigned, pressing the button will automatically
set the remote to operate the respective component.
• Refer to "Preset Code List" on pages 51–53 for the
components and manufacturers available. You should
have no problem controlling a component if you find
the manufacturer in this list, but you can only set
these codes for the button that is assigned to that
component. So, for example, the TV codes can only
be set to the TV/SAT button.
Please note that there are cases where only certain
functions may be controllable after assigning the
proper preset code, or the codes for the manufacturer
in the list will not work for the model that you are
using.
• Refer to "Controlling the Rest of Your System" on
pages 49 & 50 for detailed explanations on how to
operate your other components.
RECEIVER
SIGNAL SELECT
1
DVD TV / SAT
DVR/ VCR FM / AM
AUTO
SURROUND
SETUP
TEST TONE
MUTE
MASTER
VOLUME
TOP MENU
DISPLAY
TUNE
P
ST
ENTER
AUDIO
TUNE
EON
P
EXIT
SEARCH CLASS
E C
1
TV CONTROL
INPUT
CHANNEL
SELECT
TV CONTROL
(power)
RECEIVER
LED
SOURCE
SLEEP
FRONT
DIMMER
SOUND
ADVANCED MODE
ROOM
CH_SELECT SETUP
1
ENTER
MENU
T.EDIT
MENU
ST
SUBTITLE
RF ATT
GUIDE
A
MPX D.ACCESS
D E
ENTER
10
2
CHANNEL VOLUME
Controlling the Rest of Your System
1 While pressing the
ENTER
Input/Control Mode Select
to preset. For the
TV CONTROL
press the TV CONTROL
while pressing the
ENTER
The LED lights.
To cancel the preset mode at any time
Press .
ENTER
The remote control will also return to the previous
mode after thirty seconds of inactivity.
2 Use the number buttons to enter the 3 digit
setup code (see pages 51–53 for "Preset Code
List").
The LED turns off.
After a code has been input the power of the compo-
nent being input will turn on or off.
The remote will return to the previous mode after
thirty seconds of inactivity.
The power of the component being input will only
turn on or off if that component is able to be turned
on directly by remote control.
3 Repeat process to assign preset codes for as
many components as you want.
• You can only input a code for the component type
written on each Input/Control Mode Select button.
• Even if you don't input a preset code for the TV (TV/
SAT Input/Control Mode Select button) you will be
able to control your TV using the dedicated TV
CONTROL on the remote.
CAUTION:
• You may not be able to use a particular code even if it
is listed on pages 51–53.
• The remote control buttons will not be able operate
other equipment unless preset with the method
above.
button press the
button you want
buttons
(Power) button
button.
47
En