Pcb (Led); Pcb (Deo); Sensor Pc; The Point Of Work - Panasonic NR-B30FG1 Service Manual

11.1.2. PCB (LED)

1. Unhook hooks of left and right side, and pull PCB
(LED) in a direction below.
Pull the connector out, and remove PCB (LED).
NOTES
• Be careful not to break PCB (LED) when it is removed
and installed.

11.1.3. PCB (DEO)

1. Remove the screw that is fixation of Cover LED.
Then remove Cover LED out
2. (2)Take PCB (DEO) out from reverse side two Hooks
of Cover LED.
3. Pull the connector out while pressing the hook.
NOTES
• Be careful not to break PCB (DEO) when it is removed
and installed.

11.1.4. SENSOR PC

1. Take Tray PC A'ssy out.
2. Rotate Cover Sensor anti-clockwise, and remove it.
3. Pull Sensor PC from inside Inner Liner like the figure.
• IN CASE REPLACEMENT SENSOR PC
1. Cut the wire at near Sensor PC.
2. Connect new Sensor PC and wire by Scotch Lock.
3. (3)Install Cover Sensor to rotate clockwise.

THE POINT OF WORK

1. Insert deeply each wire one by one in Scotch Lock.
• The Scotch Lock is the structure that can connect
unstripped wires. Then it is unnecessary to use wire
stripper. (When you connect wires that was peeled
off film, it is easy to come off them.)
2. The lid (color painted) of the Scotch Lock is crimped
with pliers. Then the lid height become in the same of
the body height of the Scotch Lock.
• When you crimp the Scotch Lock with pliers, please
work while holding these wires to the Scotch Lock
side so that these wires should not come off.
34