Cable Installation; Figure 3-1. Coaxial Cable Installation - Garmin GPS 400W Installation Manual

3.8 C able Installation
3 3 B
1. Route the coaxial cable to the rack location keeping in mind the recommendations of Section
2 .6. Secure the cable in accordance with good aviation practice.
3 6 2 H
2. Trim the coaxial cable to the desired length and install the BNC connector (330-00087-00) per
the cabling instructions on
connector manufacturer's instructions for cable preparation.
The card-edge connector may be used to terminate shield grounds to the 400W Series back plate.
Feed wires through the connector backshells before insertion into the 25-, 44-, and 78-pin connectors.
Contacts for the 25-, 44-, and 78-pin connectors must be crimped onto the individual wires of the aircraft
wiring harness. The following table lists contact part numbers (for reference). See
recommended crimp tools.
Page 3-6
Rev. F
F igure 3-1. If the connector is provided by the installer, follow the
3 6 3 H

Figure 3-1. Coaxial Cable Installation

T able 3-3 for
3 6 4 H
400W Series Installation Manual
190-00356-02