Samsung SRF679SWLS User Manual page 20

3. Pull and remove the hinge lever ( 5 ).
Remove the ground screw ( 6 ) attached
to the upper left door hinges with a philips
screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
(2)
(7)
4. Open the door (more than 90°), lift from the
middle hinge and remove the door.
- Due to its design features, you can
disassemble and re-assemble the door when
the door is open.
(The holes in the Door Shaft and the Door
Middle Hinge are deliberately tilted at specific
angles so that it is difficult to disassemble and
re-assemble with the door closed.)
Place the door, inside facing up, on a
non-scratching surface.
CAUTION
DA68-03022B (EN)-04.indd 20
Door Middle Hinge
(6)
- If the Auto Closing Hinge is aligned to be
vertical as shown in the figure, align it to be
parallel by using the Door Middle Hinge.
(Refer to No.5 for the disassembly of the Door
Middle Hinge)
CAUTION
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+).
Remove the 2 hex head bolts ( 9 ) attached
to the lower left and right door hinges with an
allen wrench (5 mm).
Remove the lower left and right door hinges
( 10 ).
English - 20
Auto Closing Hinge
Check the direction
Do not use a flat head screwdriver to align
the Auto close Hinge.
It may get damaged. Use the Door middle
Hinge instead.
(10)
(8)
(9)
Allen wrench
14. 6. 23. 2:47