Do you have a question about the Dryer and is the answer not in the manual?
Questions and answers
Judi Ash
February 10, 2025
How do you male it beep when dryer is done on DR5 model
1 comments:
Mr. Anderson
February 11, 2025
The Speed Queen dryer has an "End of Cycle Signal" feature. To enable the beep when the drying cycle is complete, set the signal volume to either "LOUD" or a level between "OFF" and "LOUD." The signal will sound when the cycle is done.
This answer is automatically generated
Sabriana Lonas
January 24, 2025
My dryer won’t signal when the cycle has ended. How do I get it turned on to do that?
1 comments:
Mr. Anderson
February 10, 2025
To enable the end-of-cycle signal on a Speed Queen dryer, select a volume level (OFF, LOUD, or a setting between the two). The signal will notify you when the cycle is complete and will stop when the door is opened or the timer is advanced to an OFF position.
Page 1
User's Guide for Dryers DRY725C_SVG Original Instructions Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 513218R3 November 2014 www.speedqueen.com...
Front Matter Front Matter WARNING WARNING FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explo- sion or to prevent property damage, personal injury or death. W033 WARNING • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any oth- er appliance.
Important Safety Instructions..............5 Before Drying..................7 Energy Saving Tips..................7 Helps and Hints..................7 Sort......................7 Load......................7 Operating Your Dryer................9 Available Drying Cycles................9 Automatic Regular/Delicate Cycle............9 Time Dry Cycle..................9 Automatic Wrinkle Out Cycle..............9 Automatic Permanent Press/Knits Cycle........... 9 To Dry Clothes..................9...
Do not reach into the dryer if the cylinder is revolving. Indicates a hazardous situation that, if not avoided, • Do not install or store the dryer where it will be exposed to wa- may cause minor or moderate personal injury or prop- ter and/or weather.
Page 6
The dryer will stop tumbling when the door is opened. Do not use the dryer if it does not stop tumbling when the door is opened. Do not use the dryer if it does not stop tumbling when the door is opened or starts tumbling with- out pressing or turning the START mechanism.
Use the correct cycle for the type of fabric being dried. which require the same time, temperature or dryness level in the • Locate your dryer so the exhaust duct is as short and straight same load. as possible. •...
Automatic Wrinkle Out Cycle W520 Available on Select Models Only Use this for items that are slightly wrinkled after sitting in a dryer Available Drying Cycles or laundry basket overnight. The cycle has a short heat setting fol- lowed by a five minute COOL DOWN.
DRY2032N_SVG End of Cycle Signal 4. Close loading door. Dryer will not operate with the door open. The volume of the signal tone may be set on OFF, LOUD or between the two selections. If a volume level is selected, the signal will let you know when the cycle is done.
Operating Your Dryer Optional Drying Rack A drying rack, Part No. 512082, is available at extra cost through your Factory Authorized Service Center. The drying rack can be used in manual cycles only for no-tumble dry- ing of articles such as tennis shoes, sweaters, stuffed toys or oth- er delicate items.
Do not obstruct the flow of combustion and ventilation air. To remove crayon or ball point ink off the dryer drum, put the heat on high and use old rags in the dryer to absorb the crayon or ink. If NOTE: Verify proper operation after servicing.
DRY2025N_SVG IMPORTANT: The lint filter must be in place in the door opening when using dryer or loading and unloading dry- er. If the filter is not in place, clothing could fall into the front air duct and get into the exhaust system, causing damage to the motor.
The dryer itself does not have an electrical fuse. An electric dryer has an electrical circuit with two fuses. • Gas dryer only – Make sure equipment and main gas line valve is turned on. • Check exhaust duct to outside to see if it is kinked, blocked or needs cleaning.
Troubleshooting Dryer Symptom Possible Cause/Solution Dryer is noisy • Check dryer for foreign objects (nails, coins, bobby pins, metal, plastic toys, etc.). Remove items from dryer. • Make sure dryer is level. Uneven leveling can cause vibration. • Normal operating sounds include the tick of timer advancing, heat source going on and off, and humming of air moving through the dryer and exhaust system.
Page 16
Troubleshooting DRY2690N 1. Serial Plate When contacting us about your washer, PLEASE GIVE THE MODEL AND SERIAL NUMBERS. The model and serial numbers are located on the serial plate. The serial plate will be in the location shown. Please include a copy of your bill of sale and any service receipts you have.
Need help?
Do you have a question about the Dryer and is the answer not in the manual?
Questions and answers
How do you male it beep when dryer is done on DR5 model
The Speed Queen dryer has an "End of Cycle Signal" feature. To enable the beep when the drying cycle is complete, set the signal volume to either "LOUD" or a level between "OFF" and "LOUD." The signal will sound when the cycle is done.
This answer is automatically generated
My dryer won’t signal when the cycle has ended. How do I get it turned on to do that?
To enable the end-of-cycle signal on a Speed Queen dryer, select a volume level (OFF, LOUD, or a setting between the two). The signal will notify you when the cycle is complete and will stop when the door is opened or the timer is advanced to an OFF position.
This answer is automatically generated
How do you adjust the end of cycle signal?