Before Drying ...6 Operating Your Dryer . . .8 Maintenance ... .11 Troubleshooting..14 Part No. 513189R2 June 2011 www.speedqueen.com...
Page 2
W A R N I N G FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death. W033 •Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Safety Information Explanation of Safety Messages Important Safety Instructions Throughout this manual and on machine decals, you Save These Instructions will find precautionary statements (“DANGER,” W A R N I N G “WARNING,” and “CAUTION”) followed by specific instructions. These precautions are intended for To reduce the risk of fire, electric the personal safety of the operator, user, servicer, shock, serious injury or death to...
Page 4
9. Do not repair or replace any part of the dryer, 17. Do not put articles soiled with vegetable or or attempt any servicing unless specifically cooking oil in the dryer, as these oils may not recommended in the User-Maintenance be removed during washing.
Page 5
26. ALWAYS follow the fabric care instructions NOTE: The WARNING AND IMPORTANT SAFETY supplied by the garment manufacturer. INSTRUCTIONS appearing in this manual are not meant to cover all possible conditions and 27. Never operate the dryer with any guards and/ situations that may occur.
Before Drying Energy Saving Tips • If loads should be damp for ironing, turn timer knob to the ENERGY SAVER setting, marked • Make sure the lint filter is always clean. with an asterisk (∗), in AUTOMATIC or TIME DRY cycles. •...
Page 7
Load • The following illustrations show the ideal load sizes for fabrics. The average load will fill the W A R N I N G cylinder one third to half full when wet. Do not wash or dry items soiled with vegetable or cooking oils.
Operating Your Dryer NOTE: The timer knob will not advance as quickly in W A R N I N G the AUTOMATIC cycles as it does in the TIME DRY cycle. The time it takes for the timer to To reduce the risk of fire, electric advance depends on the type and size of the load shock, serious injury or death to being dried.
To Dry Clothes 4. Close loading door. Dryer will not operate with the door open. IMPORTANT: Refer to the INSTALLATION INSTRUCTIONS before using dryer. IMPORTANT: Before using dryer for the first time, use an all-purpose cleaner or a detergent and water solution and a damp cloth to remove shipping dust from inside of dryer drum.
End of Cycle Signal 6. Select optional EXTEND TUMBLE setting to continue tumbling items at no heat. This The volume of the signal tone may be set on OFF, prevents wrinkling when garments cannot be LOUD or between the two selections. If a volume removed from the dryer immediately.
Maintenance Lubrication Exhaust System W A R N I N G All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. To reduce the risk of electric shock, Additional lubrication will not be necessary. disconnect the electrical service to the Care of Your Dryer dryer before cleaning.
Lint Filter Notch on Flat area of rear piece of insert knob The lint filter is located at the front of the dryer in the lower part of the door opening. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. Remove lint filter cover, clean lint filter and replace cover.
Page 13
8. Place rear piece onto door handle assembly. 9. Reinstall door handle onto door panel by sliding the two center hooks into the notches of the door panel. Refer to figure below. Center Hook DRY2338N DRY2338N 10. Screw handle to door panel using screws removed in step 4.
Troubleshooting Try these troubleshooting tips before making a service call – You may save time and money! Dryer Symptom Possible Cause/Solution • For dryers equipped with a power cord, make sure the power cord is plugged all the Dryer won’t start way into the electrical outlet.
Need help?
Do you have a question about the 513189R2 and is the answer not in the manual?
Questions and answers