Pairing To A Trf-Ge1 And/Or Mrx-20 - Universal Remote TRG-200 Owner's Manual

Pairing to a TRF-GE1 and/or MRX-20

Before you can begin to use the TRG-200 Umotion remote, it is
necessary to pair it with either a TRF-GE1 or the MRX-20 Advanced
Network System Controller.
If pairing with a TRF-GE1, press and hold the pairing button (locat-
ed on the bottom of the unit) for three seconds to enter the pairing
mode. When the TRF-GE1 enters pairing mode, the Status LED
flashes orange. A successful pairing is confirmed when the Status
LED flashes green three times. The MRX-20 is paired, by your
Custom Professional, using the URC Accelerator PC software.
To pair the TRG-200, press and hold the Main and Sel buttons for
three seconds. Once paired, the Umotion button will flash three
times. Keep in mind, a TRG-200 remote can only be paired with
one MRX-20/TRF-GE1 at a time. If it is paired with a new MRX-
20/TRF-GE1, the previous configuration will no longer work.
TRG-200 U
MOTION
Page 5
R
EMOTE
Press and hold
Main and Sel for
three seconds.
Once paired, the
Umotion button
will flash three
times.