Advertisement
B
Receiver (parent/carer's unit)
14
12
B
RECEIVER UNIT (PARENT/CARER'S UNIT)
B-1 Brightness control--------------------------------
B-2
Brightness control-------------------------------
B-3
Volume control/Off/On switch-----------------
B-4
DC power 9V--------------------------------------
B-5
Power / Charge LED----------------------------
B-6
Speaker--------------------------------------------
B-7
Channel Switch 1-2-3--------------------------
B-8 Vox. control switch------------------------------
B-9
Channel LED 1-2-3-----------------------------
B-10 Vox on-off light-----------------------------------
B-11 1.5" Display LCD--------------------------------
B-12 Battery Compartment--------------------------
B-13 A/V output-----------------------------------------
B-14 Wall / Belt mounting clip----------------------
4
www.childcareproducts.com.au
11
9
10
1
2
8
7
6
13
5
increases brightness.
decreases brightness.
set speaker level, switches off the
power to the unit completely.
plug mains adaptor connector into
this socket.
lights when unit is switched on.
provides clear sounds.
select channel 1, 2, or 3
(whichever has less interference).
sound activation system.
channel selection lights.
indicates if sound activation
system is on or off.
display screen.
supplied with Ni-MH batteries.
connects to TV set in via AV cable.
clips onto belt or can be wall mounted.
Place your Transmitter's Unit (1.5 to 2 metres) away from the baby. Be
certain the Receiver's Unit and Transmitter's Unit are set on the same
channel. Check reception regulary by following the previous step above.
Adjust the volume to a comfortable level for your environment. Use the
Receiver's Unit far enough away from the Transmitter's Unit so as not to
get feedback. During use of the monitor, if the sound or picture quality
deteriorates you may be reaching the limits of the monitor's range. If this
happens, you will need to move the Receiver's Unit in closer proximity to
3
the Baby's Unit. If one channel has poor reception try one of the other
channels. Test the Automatic Night Vision (infra red sensors around the
lens) by darkening the room where the Baby's Unit is located.
4
NOTE: It is possible for the Receiver's Unit to pick up sounds or display
interference from other signal producing devices which broadcast in the 2.4
GHz frequency range. To minimise this potential problem, three
independent channels have been provided. If you experience interference
while using one channel setting, simply switch the Receiver's Unit and
Transmitter Unit, to another channel. Selecting a channel is usually a one
time adjustment. If interference persists on all channels, please refer to
the Troubleshooting section at the end of these instructions.
Adjustable volume control
The level at which you want to hear your baby's sounds can be set and
adjusted via the rotary control (B-3) on the receiver.
Belt/Wall mounting clip.
When the batteries of the receiver unit are charged, the unit can be
carried around giving you freedom of movement while still monitoring your
baby, Use the belt clip (A-9) to attach the unit to your clothing, or hang on
the wall with appropriate fixture.
Guidelines for Good Reception
www.childcareproducts.com.au
9
Advertisement
