First Time Auto Tuning; Watching Tv; Select A Channel - Panasonic Viera TH-L32XV6G Operating Instructions Manual

First time Auto Tuning

Automatically sets up the TV and searches for available TV channels when the TV is turned on for the first time.
●
These steps are not necessary if the setup has been completed by your local dealer.
●
Please complete connections (p. 6 - 9) and settings (if necessary) of the connected equipment before starting Auto
Tuning. For details of settings for the connected equipment, read the manual of the equipment.
Plug the TV into mains socket and turn power on
1
●
Takes a few seconds to be displayed.
Select the following items
2
Set up each item by following the on-screen instructions.
Select your language
Select [Home]
Select [Home] viewing environment to use in your home environment.
●
[Shop] is for shop display.
●
To change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.
Set up the network connection
Select your country
Select your area
● When selecting [CATV/Other], press the OK button, and then select the Channel Plan from Indian CATV, South
Africa, American System, American CATV or Japan CATV.
Auto Tuning is now complete and your TV is ready for viewing.
If tuning has failed, check the connection of the network, RF cable, and then follow the on-screen instructions.
Note
● The TV will automatically go into Standby mode when no operation is performed for 4 hours if [Auto Standby] in the
Timer Menu is set to [On].
●
The TV will automatically go into Standby mode when no signal is received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu is set to [On].
●
To retune all channels
●
To add the available TV signal mode later
●
To initialise all settings

Watching TV

Turn power on
1
(TV)
Select TV mode
2

Select a channel

3
up
down
th_32_39ev_xv6gkmx_1075.indb 12 th_32_39ev_xv6gkmx_1075.indb 12
[Auto Tuning] in [Tuning Menu] (Setup Menu)
[Add TV Signal] in [Tuning Menu] (Setup Menu)
[Shipping Condition] in [System Menu] (Setup Menu)
or ● Mains power On / Off switch should be on. (p. 11)
(Remote Control)
● To select two-digit channel position number, e.g. 39
or
12
1/25/2013 6:09:51 PM 1/25/2013 6:09:51 PM