Sony VPL-FE100U Operating Instructions Manual page 8

Location and Function of Controls
Control panel
4
5
6
7
1 ON key and indicator
Press to turn on the power of the projector.
The indicator lights when the key is pressed.
The indicator flashes for about six minutes after the
power is turned off by pressing the STANDBY key, as
the fan runs for six minutes to cool down the inside of
the projector. The indicator flashes quickly for one
minute, during which you will not be able to turn the
power back on with the ON key.
2 STANDBY key and indicator
Press to make the projector enter standby mode.
The indicator lights to indicate that the projector is in
standby mode.
3 LIGHT key
Illuminates the key indicators in orange when the
projector is turned on. Illuminates the indicators for the
relative keys in green when this key is pressed during
operation. Press again to turn off the indicators.
Pressing this key and the RESET key simultaneously
has the same function as the SYS SET key on the
Remote Commander. Use when the PC-3000 signal
interface switcher is used in the system or the system
connections are changed.
8
(GB)
3
LIGHT
+
RESET SYS SET
MUTING
PIC AUDIO APA
INPUT SELECT
VIDEO SELECT
VOLUME
INPUT A INPUT B INPUT C
POWER SAVING LAMP FAIL
COVER FAIL
1 2
FAN FAIL
3 4
HIGH TEMP
8 9
2
STANDBY
+
RESET
–
PATTERN ZOOM SHIFT
4 APA (Auto Pixel Alignment) key
Adjusts the position of the picture on the screen
automatically so that the picture is clearly visible when
the signals are input from a computer.
5 MUTING keys
Cut off the picture or sound temporarily.
PIC: Press to cut off the picture. Press again to
restore the picture.
AUDIO: Press to cut off the sound output from the
speakers or the AUDIO OUT jacks. Press again or
press the VOLUME + key to restore the sound.
6 VOLUME +/– keys
Adjust the volume of the built-in speakers and output
level of the AUDIO OUT jacks.
+ : Increases the volume.
– : Decreases the volume.
1
ON
!•
!¶
MENU
!§
!∞
ENTER
!¢
!£
FOCUS
!™
!¡
!º