Table of Contents
Advertisement
Installation Steps
The following is the general sequence of steps to follow in installing the
84x Reader. Each step is explained in further detail in the sections that
follow.
1.
Mount the reader backplate only (the reader will be mounted later).
Refer to "Mounting the Reader" below.
2.
Connect the reader. Refer to "Connecting the Reader" on page 6.
3.
Mount the reader to the backplate. Refer to "Mounting the Reader"
below.
4.
Test the reader. Refer to "Testing the Reader" on page 22.
5.
If necessary, refer to "Troubleshooting Guide" on page 23 for
troubleshooting information.
Mounting the Reader
The reader comes with a backplate suitable for mounting directly onto a
standard U.S. electrical single-gang box. The reader may also be mounted
directly onto a hollow wall. The reader is supplied with a weather-
resistant gasket.
The figures listed below begin on the next page. Refer to the appropriate
figure for the type of reader you are mounting.
Figure 1, "Model 84x Reader - Gang Box Mounting," on page 4.
Figure 2, "Model 84x Reader - Wall Mounting," on page 5.
Model 840/845 Contactless Smart Card Reader
3
Advertisement
Table of Contents
