Communications Settings
Testing for Current Settings
Perform the following steps to test for current settings:
NOTE: RS-232 mode for Revision B printed circuit boards and higher.
1.
Remove power from the reader.
2.
Place a mini-jump over both pins of JP4.
3.
Add power to the reader and listen for the number of beeps.
NOTE: The number of beeps indicate the current communications mode
set.
•
1 beep = Supervised F/2F
•
2 beeps = Unsupervised F/2F
•
3 beeps = Strobe
•
4 beeps = Wiegand 4001
•
5 beeps = RS-232
4.
Remove power from the reader.
5.
Place a mini-jump over one (1) pin of JP4.
6.
Add power to the reader and resume normal operations.
Model 840/845 Contactless Smart Card Reader
9