Table of Contents
Advertisement
TROUBLESHOOTING
POSSIBLE
EASY SOLUTION
PROBLEM
Tea Maker
• Check that the power plug is securely inserted into the
will not
outlet.
switch 'ON
• Insert the power plug into an independent outlet.
• Insert the power plug into a dif erent outlet.
• Reset the circuit breaker if necessary.
• For additional safety the Tea Maker is i tted with
a thermal cut out. In the event of severe overheating,
the Tea Maker will automatically shut down to prevent
further damage. Should this continue, call the autho-
rised service centre.
The Tea
• Check that the Glass Jug is securely positioned on the
Maker will
Power Base.
not work
The LCD light
• The Tea Maker TM 8010 goes into standby mode if not
has gone out
used for 3 minutes. When in standby mode, the LCD
screen will cease to illuminate.
• To re-activate the Tea Maker out of standby mode:
- Remove then replace the Glass Jug from the Power
Base.
- Press any button on the Power Base except the HOT
WATER|Cancel or TEA|Cancel buttons.
The LCD screen will re-illuminate.
I cannot
• Certain features cannot be selected or changed dur-
select
ing the heating or brewing cycle. The LCD screen may
a certain
temporarily change or a sound alert may be heard, but
function
no changes to the cycle will be made.
The LCD
• The LCD screen will display a l ashing 'RESET' when
screen
there is a resettable electronic issue. Remove the plug
displays
from the wall outlet, wait 5 seconds, then plug back in.
'RESET'
• Call the authorised service centre if the 'RESET' mes-
sage continues.
28
TROUBLESHOOTING
POSSIBLE
EASY SOLUTION
PROBLEM
The LCD
• The LCD screen will display a l ashing 'ERROR' when
screen
there is a non-resettable issue with the appliance.
displays
Should this occur, call the authorised service centre.
'ERROR'
I would like
• Even when unplugged from the wall outlet, the Tea Mak-
to have the
er will remember the last setting used for each function.
Tea Maker's
• To restore the Tea Maker's default settings for each
default
function, simultaneously press and hold AUTO START
settings back
and KEEP WARM buttons for 2 seconds.
The 'BASKET
• The basket cycle is only operational during brewing
CYCLE'
cycles that are under 10 minutes.
feature /
• The Tea Basket cannot be lowered during the heating
BASKET
up phase of normal operation.
button does
not work
After boiling
• This is normal for the functionality of the Tea Maker.
water,
bubbles
appear
around the
temperature
sensor
My tea tastes
• Tea taste is a personal preference and may require ex-
too weak or
perimentation to get it to your liking. For stronger tast-
too strong
ing tea, increase the amount of tea or brew time (see
Page 15 and 21). For a weaker tasting tea, decrease the
amount of tea or brew time (see page 15 and 21).
There is
• This is normal. The noise is from the magnet located
a rattling
inside the jug post and may be heard when the Tea
noise inside
Basket is not attached.
the Glass Jug
Advertisement
Table of Contents
