Establishing A Tcp/Ip Session For The Gigabit Ethernet Switch Module Using The Management Module - Cisco Ethernet switch Installation Manual

Establishing a TCP/IP session for the Gigabit Ethernet
switch module using the management module
To establish a TCP/IP session for the Gigabit Ethernet switch module using the
management module, complete the following steps:
1. Log on to the management module as described in the BladeCenter
Management Module User's Guide. If necessary, obtain the IP address of the
management module from your system administrator. The
management-module window opens.
2. From the I/O Module Tasks menu, click Management.
3. In the I/O Module Management section, click the bay number that
corresponds to the location of the Gigabit Ethernet switch module that you
installed. The applicable bay number (in this example, bay 1) appears in the
bottom of the window, followed by other related Gigabit Ethernet
switch-module information, including the IP address. The switch-module
information is divided into two sections: Current IP Configuration and
New Static IP Configuration.
4. In the IP address field in the New Static IP Configuration section, type the
new TCP/IP address of the Gigabit Ethernet switch module; then, click
Save.
Note: The management module does not check for invalid IP addresses.
5. Click Advanced Management. You can now start a Web-interface session, a
Telnet session, or a Secure Shell (SSH) session.
Note: The default setting for the SSH session is disabled. To enable this
setting, you must use the command-line interface (CLI).
22
Cisco Systems Intelligent Gigabit Ethernet Switch Module: Installation Guide