Beko refrigerator User Manual page 17

11. Reposition plugs and hinge pin
bushings on top of doors on the
opposite side of both doors. Use
small flat-headed screwdrivers to
remove plugs and bushings. Take
care not to mark doors.(9)
12. Reposition left hand side feet
on the opposite side. Unscrew
and reposition the bottom hinge
bushing. (10)
13. Unscrew and remove the upper
door middle hinge pin bushing/
door stopper using a cross-headed
screwdriver. Important: This part
cannot be used on the opposite
side; left hand side middle hinge
pin bushing/door stopper part is
supplied in the plastic bag.(11)
14. Re-fit the upper hinge on the
left hand side using flat-headed
screwdriver.(12)
15. Fit upper door left hand side middle
hinge pin bushing/door stopper
supplied in the plastic bag using
cross-headed screwdriver.(13)
16. Reposition three small plastic plugs
on the left hand side, which are
covering middle hinge holes, on the
opposite side to cover holes left
empty.(14)
17. Locate and re-fit upper door to
upper hinge and hold the door firmly.
(15)
18. Locate the middle hinge pin to
middle hinge pin bushing of upper
door on the left hand side and re-fit
the middle hinge.(16)
19. Reposition the two screws fitted to
lower hinge holes on the left hand
side at the bottom of the cabinet on
the opposite side.(17)
20. Locate and re-fit lower door to
middle hinge pin and then re-fit the
lower hinge on the left hand side.
(18), (19)
21. Carefully stand the appliance
upright and adjust the two front feet
if necessary.
22. Check that doors open and close
easily, they are aligned correctly
and that there are no gaps allowing
air into the cabinet. If there are
gaps between the door seal and
the cabinet, adjust the door seal by
gently pulling away from the door
using fingers.
23. Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
24. Put all items, fittings back in the
appliance.
25. Fit upper door top trim and front top
panel plastic hinge covers. Upper
door top trim hinge covers are
supplied in the plastic bag.(20)
26. Wait for at least 4 hours to allow the
system to settle before switching
on.
27. Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
17
EN