Behringer Hi Band Flanger HF300 Quick Manual

HI BAND FLANGER HF300
Ultimate High-Band Flanger Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER HI BAND FLANGER HF300.
This high-quality effects pedal delivers incredible flanging effects one octave higher than usual to take
your guitar or keyboard to a new level.
Originally, the flanger effect was generated with two tape recorders running synchronously. The same
audio signal was recorded on both machines. If you put a finger on the left spool of one of the machines,
the spool and the playback speed are slowed down. The generated delay results in phase shifting
of the signals.
1. Controls
(2)
(1)
(5)
(8)
(1) The MANUAL control adjusts the delay length and determines the starting point for the
modulation range. If DEPTH is set to minimum, it controls a static comb filter effect between dry
and delayed signal, which can be used to create resonator-like sounds.
(2) The DEPTH control adjusts the flanger sweep range according to the delay time.
(3) The RATE control adjusts the speed of the flanger's low frequency oscillator.
(4) The RES(onance) control determines the amount of output signal fed back to the flanger input to
increase the resonance effect. This adds a jet stream like sound to the flanger effect
(5) The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
(6) Use the footswitch to activate/deactivate the effect.
(7) Use this 1/4" TS IN connector to plug in the instrument cable.
(8) The 1/4" TS OUT connector sends the signal to your amp.
(3)
(4)
(7)
(6)