Table of Contents
Advertisement
Important Note:
Make sure that all drivers who will be operating the AutoCommand® are fully
aware of the safety precautions installed and their limitations. Stress the impor-
tance of switching the On/Off control switch to the "OFF" position (down)
every time the car is serviced. Show the user how the control switch must be
turned off and on again after pulling out the key before leaving the car. Give the
user a copy of the tan colored page - USER TIPS AND NOTES so that they can
familiarize themselves with the product.
USER INFORMATION:
The brown USER TIPS & NOTES sheet gives you further detail regarding
daily use of this product. Any modifications not expressly approved by Design-
Tech will void the user's authority to operate the equipment.
OTHER ACCESSORIES
The following installation accessories are available through your dealer or Design-
Tech. All prices are in US dollars. Shipping and handling costs are included.
#20041
VATS kit
(to work with the GM PASS key system)
#20043
Bosch 30 amp relays
#20049
Wire harness for above relay
Please have model number and diagnostic code ready
before calling tech support
7955 Cameron Brown Ct; Springfield, Virginia 22153 USA
Tel: (703)866-2000 or (800)337-4468
www:designtech-intl.com
Page 18
$14.95
$9.95
$9.95
20022
!! WARNING !!
Do not connect this AutoCommand® to a manual transmission vehicle.
Doing so could cause serious property damage, personal injury, and will
void all warranties.
Tools required to install the AutoCommand® unit:
Wire cutters/strippers
Pliers
Test meter
We highly recommend that all connections be soldered for reliability.
Parts list
AutoCommand® module
Baggie of Parts
Control harness (10 position)
6 Power & Ignition wires
Parts kit in plastic baggy:
30 A Fuse
On/Off control switch
Window decal
Hood pin switch set
20022
Soldering iron
Screwdrivers
Drill and 1/2" bit
3 Tab connectors
Warning Label
Ring terminal
2 cable ties (not pictured)
Page 3
Hide quick links:
Advertisement
Table of Contents
