Advertisement
operation
Switching the Heater on
The controls are located on the right hand side, on top of the
appliance. Lift flap to access the controls (Figure 3).
The button marked '
' controls the electricity supply to the
electronic thermostat. An indicator beside the '
when the unit is powered on.
Setting Desired temperature
The heater is fitted with an adjustable thermostat enabling
the room temperature to be controlled by adjusting the slider
accordingly (Figure 4). The minimum setting '
room temperature of approximately 5
for protection against frost. The 'MAX' setting represents a room
temperature of approximately 30
the elements are actually heating.
Turn on the heater using the '
slider to the desired position. When the room temperature has
reached the desired level, the power to the elements will be
reduced, the heater will then maintain the room temperature at the
chosen level.
!
notE: Should your heater fail to come on when the thermostat
slider is at a low setting, this may be due to the room
temperature being higher than the thermostat setting.
Limiting the thermostat setting
Before wall mounting the product the installer may wish to limit
the heat selection slider movement for the operator. This may
be achieved by removing the two (2) plastic pins (refer to 'x' in
Figure 5) from the rear of the thermostat moulding using pliers and
inserting them in the preferred holes to limit the slider movement.
Safety - overheat protection
For your safety this appliance is fitted with a thermal cut-out. In
the event that the product overheats for some reason, the cut-out
prevents excessive temperatures on the product by cutting the
power to the heater. Once the heater has cooled down, it will reset
automatically, it will continue to cycle on and off automatically until
the reason for overheating is removed.
Figure 3
1367 Industrial Road
Cambridge ON Canada N1R 7G8
1-888-346-7539
www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2011 Dimplex North America Limited
2
' button shows
' represents a
C (41
F) and may be used
o
o
C. The '
' symbol glows when
o
' button and move the thermostat
Figure 4
*
Maintenance
Cleaning
WArnInG: Always disconnect from the power supply before
cleaning the heater.
Before commencing cleaning, turn off the heater and allow it to cool.
Disconnect the electricity supply to the appliance.
The outside can be cleaned by wiping it over with a soft damp cloth
and then dried. Do not use abrasive cleaning powders or furniture
polish, as this can damage the surface finish.
To release heater from the wall bracket for cleaning or redecoration,
depress latch on both brackets (see Figure 2) and hinge forward.
Warranty
The manufacturer warrants the heating elements and components of the
enclosed product against any defect in material or workmanship for a
period of two years. In full satisfaction of any claims under this warranty the
manufacturer will repair or replace without charge in its factory or in the field
as it alone may decide any parts which in its operation are defective.
The manufacturer shall not be responsible for any transportation or shipping
costs in relation to such repair or replacement except as specifically
assumed by it. Misuse of this product or repairs by persons other than the
manufacturer's authorized personnel without the manufacturer's written
approval, will void this warranty.
This warranty is in lieu of all other warranties or conditions whether express
or implied including but not limited to those of merchantability or fitness for
purpose, and shall constitute the sole remedy of the purchaser and the sole
liability of the manufacturer in respect of the sale of the product whether
in the nature of breach or breach of fundamental term or of negligence or
otherwise.
The manufacturer shall not be liable for any special indirect or consequential
damages or for any damages resulting from removal or replacement of a
heater subject of a warranty claim without the manufacturer's authorization.
This warranty is transferable by the original consumer purchaser of the
product. Any claims under this warranty must be submitted in writing to:
Dimplex North America Limited, 1367 Industrial Road, Cambridge Ontario,
N1R 7G8, Canada.
!
note
on Disposal: Do not dispose of the unit with general
household waste. The device must be taken to a local waste
disposal plant.
Figure 5
MAX
'x'
www.dimplex.com
Advertisement
