Electric Connection - TECNOEKA KCV 96 P Use And Instruction Manual

_ TECNOEKA Srl _________________________________________________________ use and instruction manual _

5. Electric connection

5. Electric connection 5. Electric connection 5. Electric connection
Before performing the electric connection, make sure that: Before performing the electric connection
Before performing the electric connection Before performing the electric connection
- the relief valve and the system can stand the appliance load (see data on the rating
plate);
- THE SUPPLY SYSTEM IS EQUIPPED WITH AN APPROPRIATE GROUND CONNECTION IN
ACCORDANCE WITH THE REGULATIONS IN FORCE;
- the omnipolar system used for the connection can be easily reached with the appliance
installed.
In the grid-connected mode, between the appliance and the grid an omnipolar switch must
be inserted, having a 3 mm minimum opening between contacts, suitable to the load used
and in accordance with the regulations in force. The yellow/green earth cable must not be
interrupted by the switch. interrupted by the switch. interrupted by the switch. interrupted by the switch.
Connection of power cable Connection of power cable
Connection of power cable Connection of power cable
Mod. KCV 96 P P P P - The terminal board is on the rear panel of the appliance. Open the terminal Mod. KCV 96 Mod. KCV 96 Mod. KCV 96
board cover by obtaining leverage with a screwdriver on the two side fins. Loosen the cable
gripper screw and allow the cable to pass through it. Arrange the conductors so that the earth
conductor is the last to detach from its terminal if the cable goes into a state of faulty traction.
Connect the phase conductor to the terminal marked with the letter "L", the neutral
conductor to the terminal marked with the letter "N" and the earth conductor to the terminal
marked with the symbol
board cover. The appliance must be connected to an equipotential system whose efficiency
must first be checked according to current legal regulations. This connection must be made
between different appliances by using the appropriate terminal marked with the symbol
equipotential conductor must have a minimum diameter of 10 mm
is at the rear of the appliance. When the appliance is operating, the supplied voltage must not
deviate from the nominal voltage value of ±10%.
Mod d d d . KCV 96 Mo . KCV 96 - For access to the terminal board, remove the rear panel of the appliance.
Mo Mo . KCV 96 . KCV 96
Loosen the cable gripper and allow the cable to pass through. Locate the conductors so that the
earth cable is the last to detach from its terminal in the event of reverse pulling. Connect the
phase conductors on the terminals marked "L1" and "L2", the neutral conductor to the
terminal marked "N", and the earth conductor to the terminal marked with symbol
according to the following lay-out:
(this electrical connection lay-out is also available near the power supply terminal board).
Tighten the cable gripper and re-fit the rear panel of the appliance. The appliance must be
connected to an unipotential system whose efficiency must be suitably verified according to
current legal regulations.
This connection must be made between different appliances using the terminal marked with
the symbol . The unipotential conductor must have minimum diameter of 10 mm
unipotential terminal is located low down at the rear of the appliance.
Make sure that after inserting the power supply cord into the terminal block it does not come
into contact with any of the cooking range's hot parts.
_ page 10 ________________________________________________________________________________________
. Tighten the ring-nut of the cable gripper and close the terminal
380 - - - - 400V~ 2N 380 400V~ 2N
380 380 400V~ 2N 400V~ 2N
N
The yellow/green earth cable must not be
The yellow/green earth cable must not be The yellow/green earth cable must not be
2
L L
2 1
The equipotential terminal
. The
2
. The