Parts Nomenclature And Assembly; Parts Nomenclature/Assembly; Connections - Kenwood P-110 Instruction Manual

Parts nomenclature and assembly

6
Verify that all of the following parts are present before carrying out the assembly procedures.
First, set the MM. AMP switch on the bottom according to the type of your amplifier. (Refer to "Connections" below.)
Dust cover
AC plug adaptor
(Only for some
areas)
Rubber mat
Audio cords
AC cord
Center spindle
Turntable platter
SPEED selector

Connections

This until has a built-in RIAA equalizer amplifier, so it can be connected to an amplifier without PHONO (turntable) input jacks.
According to the amplifier, set the MM.AMP switch on the bottom cover.
When the unit is connected
to the PHONO (MM) jacks :
When the unit is connected
to the AUX jacks, etc. :
Caution:
Do not apply oil or lubrication to the motor, tonearm, or any of the turntable's mechanisms.
Do not plug in the power cord until all connections are completed.
SPEED
45
33
Rear panel of
White
the amplifier
Audio cord
MM.AMP
OFF
ON
Red
Rear panel of
the amplifier
MM.AMP
OFF
ON
Motor puller cover
EP adaptor
Arm elevator
Cueing lever
Arm rest
Tonearm
Cartridge
CUT
CUT key
L
R
PHONO
L
R
AUX
Installing the hinges
Removing the plastic tie
After connections, remove the plas-
tic tie that retains the tonearm.
Releasing the arm rest lock lever
MM.AMP
OFF
ON
P-110 (En)
Dust cover
Hinge
plastic tie
Tonearm