Mazda 2015 5 Owner's Manual page 233

Instant replay
This function allows you to rewind and
replay the program that you were
previously or are currently listening to.
Press the instant replay button (
When the seek tuning button (
pressed (about 1.5 seconds), playback
starts from the beginning of the current
program.
When the seek tuning button (
pressed twice, playback starts from the
beginning of the previous program.
When the seek tuning button (
pressed for about 1.5 seconds or longer,
the program is reversed while the button
is being pressed.
When the seek tuning button (
pressed (about 1.5 seconds), playback
starts from the beginning of the next
program. When the seek tuning button
( ) is pressed (about 1.5 seconds) while
the last program is being played, the
instant replay mode is cancelled.
When the seek tuning button (
pressed for 1.5 seconds or longer, the
program is fast-forwarded while the
button is being pressed. When pressing
and holding the button until the end of the
program, the instant replay mode is
cancelled.
When the instant replay button (
pressed again, playback is paused, or
playback starts if it has been paused.
Instant replay (PAUSE)
If the instant replay button (
pressed while the instant replay mode is
off, instant replay mode is turned on in a
paused condition (PAUSE). Press the
instant replay button (
resume playback from the point at which
it was paused.
).
) is
) is
) is
) is
) is
) is
) is
) again to
NOTE
If the channel is changed, the instant replay
l
buffer data is deleted.
After turning on the power and switching to
l
SIRIUS digital satellite radio mode, the
instant replay mode is not available for
several seconds after changing channels.
Initialization of ID code
If the registered ID code is forgotten,
return the ID code to the default [0000] by
performing the following steps:
Setting condition: SAT mode
(Master code input preparation)
1. Press and hold the scan button (
then press channel preset button 4.
Hold both buttons together for 1.5
seconds.
2. ENTER PIN appears for three
seconds which indicates that it is in
code input mode.
3. SR1 - - - - appears, which indicates
that it is ready for code input.
(Master code input)
4. Input the master code using the channel
preset buttons 1-4.
(The master code is already set at the
time of factory shipment.)
(Master code input determination)
5. Determine the master code which has
been input by pressing the scan button
( ).
6. PIN CLEARED appears which
indicates that the master code input has
been completed.
7. The ID code is set to the default [0000]
and the initialization process is
completed.
Interior Comfort
Audio System
),
6-37