Recording (Digital Input); Digital Recording - Kenwood DMF-3020 Instruction Manual

Recording (DIGITAL input)

Recording is possible using recordable Mini Discs. When this unit is connected with a component equipped with digital output,
such as a CD player, through a digital cord or optical fiber cable, the signal input through the DIGITAL input jack can be recorded
in the digital format (this recording is referred to as digital recording). Enjoy high-quality sound of digital recording!
Preparation
1
Open the write protect tab of the Mini Disc to make it recordable.
2
Load the Mini Disc.
3
Check the remaining recording time.
4
Set the amplifier's input selector to the source to be recorded.

DIGITAL recording

1
Adjust the settings if required.
1
Switch the REC MODE on.
REC MODE/CHARAC.
2
Select the setting adjustment mode.
JOG DIAL
4
4
3
Set the selection.
SET
Go to step 2 if setting adjustments are not required.
2
Select one of "DIGITAL 1, 2 ".
REC INPUT
3
Select AUTO or MANUAL. (Remotecontrol unit only)
AUTO/MANU.
¢
¢
Each press switches the mode.
1 REC MODE : off
2 REC MODE : on
The modes are switched by rotating the JOG DIAL.
AUTO CUT? : AUTO CUT on/off selection.
AUTO TIME? : Setting of the time for detecting a no-sound
blank section during automatic track number
marking.
AUTO LEVEL? : Automatic track number marking no-sound
blank detection level and SOUND SYNCHRO
REC, AUTO CUT and REC AUTO PAUSE sound
detection level setting.
REC= WRITING? : Setting of the UTOC writing after recording.
÷ For details on the setting adjustment modes, see "REC MODE key".
Each press switches the mode.
1 ANALOG : Analog "stereo mode"
2 DIGITAL 1 : Optical input mode
3 DIGITAL 2 : Coaxial input mode
4 MONO
: Analog "monaural long-play mode"
Each press switches the mode.
1 goes off (AUTO) : Track numbers are marked automatically.
2 MANUAL
: Track numbers can be marked as desired.
DMF-5020/DMF-3020/MD-203 (En)
8
o
¢
¢
¢
29