ATTI Shadow Tracker Premier Hardware Manual page 3

Federal Communications Commission (FCC) Notification
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment operates in a commercial environment.
Properly shielded and grounded cables and connectors must be used in
order to meet FCC emission limits.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the
interference at his own expense.
Only peripherals certified to comply with the Class A limits may be
attached to this device. Operation with non-certified peripherals or
peripherals not recommended by Advanced Tracking Technologies, Inc.
is likely to result in interference to radio and television reception.
Unauthorized changes or modifications could void the user's authority to
operate the equipment.
This device must be operated as supplied by Advanced Tracking
Technologies, Inc.. Any changes or modifications made to the device
without the express written approval of Advanced Tracking Technologies,
Inc. may void the user's authority to operate the device.
Advanced Tracking Technologies, Inc. is not responsible for any radio or
television interference caused by using other than recommended cables
and connectors or by unauthorized changes or modifications to this
equipment.
CAUTION: The Shadow Tracker Premier has maximum
transmitted output power of 200mW. It is required that the
transmit antenna (located inside the Shadow Tracker™ Premier)