Assembly Instructions - Breckwell SW180 Owner's Operation And Instruction Manual

3.0

3.1 ASSEMBLY INSTRUCTIONS

This appliance is offered in three different confi gurations of which you get to choose. You have the option to install your new heater
as a freestanding heater on a pedestal,on legs or as a fi replace insert. You must purchase the desired kit separately from your
appliance dealer. Read and follow the directions in this manual and inside the chosen kit to ensure proper assembly, installation
and operation of your new wood heater.
While installing the desired kit you must install the primary air damper. The damper is shipped in place. Simply secure the damper
limit screw through the damper's slot and into the pre-threaded hole.
The assistance from a second person is strongly suggested. Please use proper lifting technic when positioning the appliance for
assembly and installation. Several methods may be used to attach the legs and pedestal to the appliance. The safest method is to roll
the appliance on its back, then attach the chosen assembly. When using this method, you should fi rst remove the fi rebrick from the
unit so as to reduce weight and possible breakage. It will be required to raise the bottom of the unit up to attach two of the legs or
the pedestal. It is recommended that you use cardboard or other means of padding to protect the fi nish on your new stove.
3.2 FREESTANDING LEG ASSEMBLY
1) Unpack the kit and ensure all components are present:
Qty Description
4 Cast Iron Legs
8 1/4-20 UNC Bolts
8 Flat Washers
2) Position the unit for assembly.
3) Using the Eight(8) 1/4-20 bolts and washers provided,
attach the legs.
4) Rotate the appliance onto the legs, being careful not to
damage the legs while doing so.
5) Make sure that the baffl e board, above the air tubes, is in
place and undamaged. DO NOT remove the baffl e board.
3.3 FREESTANDING PEDESTAL ASSEMBLY
The pedestal should come assembled to the base, ready to install on your appliance. You can either roll the appliance onto its back
as above or locate the pedestal assembly in the approximate fi nal location, then set the appliance atop the pedestal.
Caution! The appliance is very heavy.
1) Unpack the Pedestal Assembly and ensure all components are present:
Qty Description
1 Pedestal Assembly
8 #10x1/2 Hex Head Screw
2) Position the appliance for assembly.
3) Attach the pedestal to the bottom of the unit using Two (2) bolts provided.
4) Attach the pedestal back to the pedestal using four(4) sheetmetal screws
provided.
5) Make sure that the baffle board, above the air tubes, is in place and
undamaged. DO NOT remove the baffl e board.
6) If an outside combustion air source is needed see the "5.1 Combustion
Air Assembly Instructions" section in this manual.
4
ASSEMBLY
Caution! The appliance is very heavy.
Part #
40566
83339
83045A
Part #
83343