Heat & Glo Bravo Owner's Manual page 35

OPTION D: Flush Wall Finish with Luxor Surround
Kiva-style fi nished in a straight wall (see Figure 11.8).
Figure 11.8 Flush wall installation with Luxor Surround
• Unit is installed using framing dimensions found in
Figure 3.2.
• Do not use nailing tabs provided on unit sides for
Option D.
• Nailing tabs are attached to the top of the unit. Install
nailing tabs using screws on upper unit sides (see
Figure 11.3).
• This places unit back 1/2 inch from framing studs such
that drywall or other material can be brought directly
across non-combustible board up to fi nishing strip.
WARNING
Fire Risk.
1/2 Inch non-combustible board installed on front
face of fi replace MUST remain in place if using
combustible fi nishing materials.
• A cardboard template is printed on unit shipping
carton and may be used to help cut drywall or other
fi nishing materials. Simply cut along line and use it as
a template. For Luxor Surround, cut an additional 3 in.
wider than the template.
3-in. GAP
SHEETROCK
EDGE
FINISHING STRIP
Heat & Glo • Bravo • 704-902 Rev. D • 5/08 35