Makita 4190D Instruction Manual page 7

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing diamond wheel
1 2
3
003526
To install the wheel, first loosen the bolt with the hex
wrench and remove the bolt and the flange. Then mount
the wheel, the flange and the bolt. The wheel should be
mounted with the Makita name on the flange side.
Press the blade stopper pin and insert it through the hole
in the wheel so that the wheel cannot revolve. Use the
hex wrench to tighten the bolt securely.
1
003527
To remove the wheel, follow the installation procedure in
reverse.
CAUTION:
When installing the wheel, be sure to tighten the
•
bolt securely.
Use only the Makita wrench to install or remove the
•
wheel.
1. Bolt
2. Flange
3. Diamond wheel
1. Hex wrench
2. Blade stopper
pin
2
Hex wrench storage
003533
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing water supply
1
3
4
5
003538
Attach the tank holder on the tank. The tank holder
should be attached around the portion shown with the
dotted line. Tighten the screw (A) to the extent that the
tank can still turn within the tank holder.
Attach the tank holder onto the motor housing. Tighten
the screw (B) securely.
003539
Connect the cap on the end of the polyvinyl tube to the
mouth of the tank. Turn the tank clockwise when making
the connection. Then tighten the screw (A) securely to
secure the tank.
7
1. Hex wrench
1
1. Tank holder
2
installing portion
2. Tank
3. Screw (B)
4. Screw (A)
5. Tank holder
1. Screw (B)
1