Kenwood X1200M Instruction Manual page 5

■ Remote cable connection (Optional accessory)
CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
■ Multi Amplifier with Remote cable connection (Optional accessory)
You can control the Bass boost level of the
second and subsequent Slave amplifiers
simultaneously from the Master amplifier.
The volume level of each amplifier is
determined by the setting of the Master
amplifier (INPUT SENSITIVITY, boost level of
the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output
of the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same
volume as the Master amplifier, adjust the
INPUT SENSIVITY to 0.2 V (max.).
CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level
knob all the way to the left.
* Commercially available parts
FUSE [30Ax3]
CENTER UNIT
(CD receiver, etc.)
Power control wire*
Master amplifier
FUSE [30Ax3]
Extension wire*
Slave amplifier
FUSE [30Ax3]
Slave amplifier
Hexagon Wrench
(Small)
FUSE [30Ax3]
Use the
attached
Hexagon
Wrench.
BATT. GND
P.CON SPEAKER OUTPUT
Remote cable
Remote controller
BATT. GND
P.CON SPEAKER OUTPUT
BATT. GND
P.CON SPEAKER OUTPUT
BATT. GND
P.CON SPEAKER OUTPUT
Remote cable (6.0 m : 19.7 ft)
L
REMOTE
R
LINE IN LINE OUT
Remote controller
LINE OUT
FILTER
RCA cable*
ON
OFF
L
REMOTE
R
LINE IN LINE OUT
LINE OUT
FILTER
ON
RCA cable*
OFF
L
REMOTE
R
LINE IN LINE OUT
LINE OUT
FILTER
ON
OFF
L
REMOTE
R
LINE IN LINE OUT
1
2
0.5
3
0.3
4
[ MIN ] 5 0.2 [ MAX ]
INPUT
SENSITIVITY [ V ]
1
2
0.5
3
0.3
4
[ MIN ] 5 0.2 [ MAX ]
INPUT
SENSITIVITY [ V ]
1
2
0.5
3
0.3
4
[ MIN ] 5 0.2 [ MAX ]
INPUT
SENSITIVITY [ V ]

English