Table of Contents
Advertisement
www.seagate.com
Table 1 Drive specifications summary for 3TB, 2TB, 1.5TB, 1TB and 750GB models (continued)
Drive Specification*
Voltage tolerance (including noise)
Ambient temperature
Temperature gradient
Relative humidity
Relative humidity gradient (max)
Wet bulb temperature (max)
Altitude, operating
Altitude, non-operating
(below mean sea level, max)
Operational shock (max)
Non-operational shock (max)
Vibration, operating
Vibration, non-operating
Drive acoustics, sound power
Idle***
Seek
Non-recoverable read errors
Rated workload
Warranty
Load/Unload cycles (25°C, 50% rel. humidity)
Supports Hotplug operation per the
Serial ATA Revision 3.2 specification
*All specifications above are based on native configurations.
** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating
environment and formatting.
* ** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.
Seagate Desktop HDD Product Manual, Rev. K
ST3000DM001 &
ST3000DM002;
ST2000DM001
–40° to 70°C (non-operating)
20°C per hour max (operating)
5% to 95% (non-operating)
40.0°C max (non-operating)
300 Gs at 2ms
2Hz to 22Hz: 0.25 Gs, Limited displacement
2.4 bels (typical)
2.6 bels (max)
2.6 bels (typical)
2.7 bels (max)
Average rate of <55TB/year. The AFR specification for the drive assumes the I/O
workload does not exceed the average annualized workload rate limit of 55TB/year.
Workloads exceeding the annualized rate may degrade the drive AFR and impact
product reliability. The average annualized workload rate limit is in units of TB per year,
or TB per 8760 power-on hours. Workload rate limit = TB transferred × (8760/recorded
power-on hours).
To determine the warranty for a specific drive, use a web browser to access the
following web page:
http://www.seagate.com/support/warranty-and-replacements/
From this page, click on "Check to see if the drive is under Warranty". Users will be
asked to provide the drive serial number, model number (or part number) and country of
purchase. The system will display the warranty information for the drive.
ST2000DM001 &
ST2000DM002;
ST1500DM003
5V: ±5%
12V: +10% / -7.5%
0° to 60°C (operating)
30°C per hour max
(non-operating)
5% to 95% (operating)
30% per hour
37.7°C max (operating)
–304.8m to 3048m
(–1000 ft to 10,000+ ft)
–304.8m to 12,192m
(–1000 ft to 40,000+ ft)
80 Gs at 2ms
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
14
1 per 10
bits read
300,000
Yes
Drive Specifications
ST1000DM003 &
ST1000DM004;
ST750DM003
350 Gs at 2ms
2.2 bels (typical)
2.4 bels (max)
2.4 bels (typical)
2.5 bels (max)
5
Advertisement
Table of Contents
