Kenwood eXcelon KAC-X10D Instruction Manual page 5

■ Multi Amplifier with Remote cable connection (Optional accessory)
You can control the Bass boost level of the
second and subsequent Slave amplifiers
simultaneously from the Master amplifier.
The volume level of each amplifier is determined
by the setting of the Master amplifier (INPUT
SENSITIVITY, boost level of the remote controller).
Setting the Master amplifier
1. Adjust the INPUT SENSIVITY to the output of
the center unit to be connected.
2. Set the LPF frequency and ISF.
3. Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1. Turn the LINE OUT FILTER switch OFF.
2. Adjust the INPUT SENSIVITY.
• To adjust the Slave amplifier to the same
volume as the Master amplifier, adjust the INPUT
SENSIVITY to 0.2 V (max.).
2CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
* Commercially available parts
CENTER UNIT
(CD receiver, etc.)
Power control wire
Master amplifier
Extension wire*
Slave amplifier
Slave amplifier
RCA cable*
Remote cable
RCA cable*
Remote controller
English 5