Fleetwood Jamboree 1990 User Manual page 54

*
*
*
*
*
*
*
*
*
*
*
*
*
Open vents and windows for ventilation.
Be sure all 12-volt DC and 120-volt AC circuit
breakers are off.
Start engine. Check instruments for proper
readings. If oil pressure indicator does not in-
dicate sufficient oil pressure, shut down engine
immediately. Have problem diagnosed by your
dealer, or other qualified chassis technician.
Be sure all other engine instruments indicate
proper readings. Run engine up to operating
temperature. Shut engine down. Check all
fluids. Top up if necessary.
During engine run, check the operation of
headlights, taillights, turn signals, backup lights,
clearance lights, license plate light, emergency
flashers. Operate the vehicle air conditioner.
Drain, flush, and sanitize the fresh water system
as outlined in the "PLUMBING" section.
Drain the holding tanks as outlined in the
"PLUMBING" section. Inspect the drain hose
for leaks. Replace if necessary - repairs are
usually not effective.
Operate all faucets and fixtures in the fresh
water system. Check for leaks at all joints and
fittings. Repair if necessary.
Inspect the LP gas system. Remove the
regulator cover, check for damage. Inspect all
pipes and fittings in the system. Check for leaks
as outlined in the "LP GAS" section. If the LP
tank shows signs of rust or corrosion, sand and
paint it as necessary.
Turn on 12-volt DC circuit breakers and inspect
fuses. Operate all 12-volt lights and accessories.
Install new batteries in battery-operated
devices.
Check monitor panel operation.
Open and operate vents and vent fans, in-
cluding the range hood fan.
48
*
*
*
*
*
*
*
*
*
*
*
*
Operate each LP gas appliance. Observe all
burner/pilot flames for proper color and size.
In any case, have the LP gas regulator adjusted
for proper pressure.
Inspect the 120-volt electrical system - power
cord, converter, all outlets, and any exposed
wiring. If defects are found, refer service to your
dealer or an authorized Fleetwood Service
Center.
Prepare the AC generator for operation follow-
ing instructions in the generator operating
manual in your Owner's Information Package.
Turn on 120-volt AC circuit breakers.
Start and run generator.
Operate 120-volt AC appliances and air condi-
tioners. Be sure to uncover air conditioner
shroud(s).
Inspect and clean the interior.
Check the sealant around all roof and body
seams and windows. Reseal if necessary. See
"SEALANT RENEWAl:' section.
Lubricate all exterior locks, hinges, and latches.
Reinstall windshield wiper blades. Check
wiper/washer operation.
Wash and wax the exterior. Inspect the body
for scratches or other damage. Touch up or
repair as necessary. Flush the underside
thoroughly.
Run thorough operational checks of steering,
brakes, engine and transmission. Operate
vehicle slowly during these checks to allow suf-
ficient circulation of fluids and reseating of
components.
Your motor home should now be ready for a new
traveling season. If you choose, your dealer can double
check your preparation and correct any defects or
make any necessary adjustments.
!--~
);;..,
I
i -