Detaching The Stand And Wall Mounting - Technika LCD22-228 User Manual

Attaching / detaching the stand and wall mounting
ATTACHING/DETACHING THE STAND
Attaching the Stand
1) Insert the TV into the stand at 45 degrees
This television requires a VESA 100 wall mount, or equivalent.
Detaching the Stand
1) To remove the base, press close and rotate 45 degrees.
2) Remove the 4 screws highlighted
IMPORTANT - Before drilling any holes in the wall ensure you are not drilling
where there could be any electric wires, water or gas pipes.
Wall mounting the TV
1) Remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
Important – If wall mounting this TV, only
use the screws already provided in the wall
mounting holes. Using other screws which
are longer could cause irreparable damage to
internal parts.
3) Remove the screw/s in the neck of
the stand (where fi tted)
For optimum viewing, if wall mounting the TV
higher than eye level, the TV should be tilted
downwards so that the TV's screen is 'face on'.
See fi g 1 and 2
2) Twist the TV into the CLOSE
position until it clicks into place
fi g 1
TV
Viewing angle
fi g 2
TV
Viewing angle
9 9