Attaching/Detaching The Stand & Wall Mounting - Technika LCD23-230 User Manual

Attaching/Detaching the Stand & Wall mounting
Attaching the Stand
Base of stand
Insert the TV into the stand
1)
Twist the TV into the CLOSE position
2)
until it clicks into place at 45 degrees
Important – If wallmounting this TV, only use the screws already
provided in the wallmounting holes. Using other screws which are
longer could cause irreparable damage to internal parts.
IMPORTANT— BEFORE DRILLING
ANY HOLES IN THE WALL ENSURE
YOU ARE NOT DRILLING WHERE
THERE COULD BE ANY ELECTRIC
WIRES, WATER OR GAS PIPES
THIS TV REQUIRES A VESA
100 WALL MOUNT, OR EQUIVALENT
To remove the stand
1) Remove base as shown opposite
2) Re move the four screws highlighted
below
4) The stand will now come off
Wall Mounting the TV.
1) Remove the four screws highlighted
below.
2) The wall mount can now be easily attached
to the mounting holes on the rear of the TV.
These holes are indicated in the picture
User Guide
100
3) Remove the two screws in
the neck of the stand.
9