Table of Contents
Advertisement
10. INSPECTION AND MAINTENANCE BEFORE RIDING
(Please refer to the components location diagram for the following components.)
ROUTINE INSPECTION
Check Items
Engine Oil
Fuel
Front
Brake
Rear
Front
Tires
Rear
Steering Handle
Speedometer, lights, and
rearview mirror
Tightness of Main Components
Abnormal Points
CAUTION:
If any problem found during routine inspection, correct the problem before using the motorcycle
again, have your motorcycle checked and repaired by the "E-TON authorized dealer" if
necessary.
ENGINE OIL INSPECTION AND CHANGE
INSPECTION:
1. Use the main parking stand to support the motorcycle
on a level ground, remove the dipstick after engine
stopped for 3~5 minutes. Wipe oil off the dipstick and
then insert it into the guide tube again (Do not rotate it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks.
Add oil to upper limit if oil is under the lower limit.
(Check cylinder, crankcase...etc for leakage.)
Copyright ©2008-2009 ETON America, all rights reserved.
Check Key Points
Is there enough engine oil?
Is it enough?
Braking condition?
(Brake lever free play: 10~20mm)
Braking condition?
(Brake lever free play: 10~20mm)
Is tire pressure normal?
2
(Standard: 1.75kg/cm
)
Is tire pressure normal?
2
(Standard: 2.0kg/cm
for 1 person, 2.25kg/cm
Does the handle vibrating abnormally or is difficult to turn?
Is it operating properly?
Do lights come on? Can it be seen clearly from behind?
Are screws, nuts loosen?
Do the previous troubles still exist?
13
2
for 2 persons)
- Quick Links:
- Specification
Hide quick links:
Advertisement
Table of Contents
