Security Code Setup - Kenwood DDX8017 Instruction Manual

Before Use

Security Code Setup

You can set a security code to protect your receiver
system against theft.
• When the Security Code function is activated, the code
cannot be changed and the function cannot be released.
Note, the Security Code can be set as the 4 digit number of
your choice.
1
Display the Security Code Setup screen
Security
If is not shown, touch
Security
to display it.
Next
MENU 3
Security code set
2
SI
1
1 Returns to the Control screen of the previous
source.
2 Calls the Sound Effects Menu. (page 88)
3 Calls the Setup Menu.
4 Allows you to start security code registration.
5 Turns the SI function On or Off.
If turned "On", the burglar alarm lamp flashes
when the vehicle ignition is off. (
• If you have already completed the code registration,
cannot touch .
Set
80
|
English
or
Prev.
Set
4
On Off
5
Security
On)
2
Start the security code registration
Set
PassWord
1
1 2
4 5
7 8
0
1 Enters the numbers to make your security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Registers your security code.
3
Enter a security code
0
—
Input a four-digit number.
4
Register your security code
Enter
5
Reenter the security code
Reenter the same security code as that you have
entered in Step 3 for confirmation.
• If you enter a different security code, the screen returns
to Step 3 (for the first code entry).
6
Register the security code again
Enter
Now, your security code is registered.
If you press the Reset button or if you disconnect
your receiver from the battery after the code
registration, you need to enter the registered
security code.
See below for details.
3
Cancel
3
6
9
2 4
Enter
Clear
9