Canon ZR 850 Instruction Manual page 79

Problem
No sound from the built-in
speaker.
Image will not appear on the
TV screen.
Tape is running, but image will
not appear on the TV screen.
Memory Card Operation
Problem
Memory card cannot be
inserted.
Cannot record on the memory
card.
Memory card cannot be played
back.
Image cannot be erased.
" " flashes in red.
Printing
Problem
The printer is not operating
even though the camcorder
and printer are correctly
connected.
Editing
Problem
Cannot record with this
camcorder video input from an
external video device
connected using a DV cable.
Open the LCD panel.
Speaker volume is turned off. Adjust the volume with the
[SPEAKER VOLUME] setting.
Check again that the camcorder is properly connected to the TV.
TV/VIDEO selector on the TV is not set to VIDEO. Set the
selector to VIDEO.
Video heads are dirty. Clean the video heads.
You attempted to play back or dub copyright a protected tape.
Stop playback/dubbing.
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
Memory card is full. Erase still images to free some space or
replace the memory card.
Memory card was not initialized. Initialize the memory card.
The folder and file numbers have reached their maximum value.
Set [FILE NOS.] to [RESET] and insert a new memory card.
Set the camcorder to
Image is protected. Cancel the protection.
The write-protect switch on an SD or SDHC memory card is set
to prevent accidental erasure. Change the position of the write-
protect switch.
Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Initialize the memory card if flashing
persists.
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to
Wrong signal standard. Refer also to the instruction manual of
the connected device.
Solution
Solution
.
Solution
mode and restore the connection.
Solution
Trouble? 79
–
33
63
64
2
65
22
60
62
44
34
61
–
62
–
–