Returning To A Pre-Marked Position - Canon ZR 850 Instruction Manual

5
Push the joystick (
to begin the playback.
D
URING PLAYBACK
6
Push the joystick (
/ again to pause the playback.
7
Push the joystick (
stop the playback.
T
O ADJUST THE VOLUME
1
Press .
FUNC.
2
Select ( ) [
VOLUME] and adjust (
volume.
• The sound from the built-in speaker
will be muted when you close the LCD
panel or while the STV-250N Stereo
Video Cable is connected to the AV
terminal.
• If you turn off the volume completely,
the icon will change to
3
Press FUNC. to close the menu.
S P M
PECIAL LAYBACK ODES
To operate the special playback modes
use the buttons on the wireless controller.
There is no sound during the special
playback modes. To return to normal
playback, push the joystick (
/ or press
PLAY
controller.
Fast Playback: Push the joystick (
towards or (
the joystick pressed down to rewind/fast
forward the tape while continuing the
playback. You can also press and hold
or on the wireless
REW FF
controller.
Reverse Playback: During normal
playback press
Frame Reverse/Advance: During playback
pause press /
for continuous frame-by-frame playback.
Slow Playback: During normal or reverse
playback press
SLOW
Double Speed Playback: During normal or
reverse playback press
) towards /
) towards
) towards to
SPEAKER
) the
.
) towards
on the wireless
)
) towards . Hold
.
. Keep pressed
.
.
NOTES
You can display the date and time of the
recording ( 55).
During some special playback modes, you
may notice some video problems (blocky video
artifacts, banding, etc.) in the playback picture.
To protect the tape and video heads, the
camcorder will enter the stop mode (
playback pause (
seconds. To resume the playback push the
joystick ( ) towards

Returning to a Pre-marked Position

If you wish to return to a particular scene
later, mark the point with the zero set
memory and the tape will stop at that
point when you rewind/fast forward the
tape.
1
While recording or during playback,
press
ZERO SET MEMORY
wireless controller at the point you
wish to return to later.
• The time code changes to
"0:00:00 ".
• Press
ZERO SET MEMORY
cancel the memory.
2
If you marked the zero memory
while recording, set the camcorder
to mode. If you marked
the zero memory during playback,
press .
3
Press to locate the zero mark.
• If the tape counter shows a negative
number, press
• appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark, disappears and the correct
time code will be displayed again.
Playback 33
) if left in
) mode for 4 minutes 30
/ .
( 10)
on the
again to
instead.