Product Overview - Toro Power Clear 518 ZR 38472 Operator's Manual

Adjusting the Control Cable
1. Slide up the spring cover and unhook the spring from
the adjuster link (Figure 9).
1. Adjuster link
2. Z-fitting
Note: You can pull up the adjuster link and cable to
make unhooking the spring easier.
2. Move the Z-fitting to a higher or lower hole on the
adjuster link as needed to obtain the 1/16-inch to
1/8-inch (2 mm to 3 mm) gap between the control bar
and the handle (Figure 9).
Note: Moving the Z-fitting higher decreases the gap
between the control bar and the handle; moving it
lower increases the gap.
3. Hook the spring to the adjuster link and slide the spring
cover over the adjuster link.
4. Check the adjustment; refer to Checking the Control
Cable.
Note: The belt may slip (squeal) in wet conditions;
to dry out the drive system, start the rotor and run it
without a load for 30 seconds.
Figure 9
3. Spring cover
4. Unhook the spring here.

Product Overview

1. Control bar
2. Recoil start handle
3. Spring cover
4. Fuel tank cap
5. Chute handle
1. Spark plug
2. Oil fill cap
3. Oil drain plug
4. Choke lever
8
Figure 10
6. Chute deflector trigger
7. Chute deflector
8. Discharge chute
9. Rotor blades
Figure 11
5. Primer
6. Ignition key
7. Electric-start button
(model 38473 only)
8. Plug-in for electric start
(model 38473 only)